4
From the "What is being scanned?" menu, choose the type of document to be scanned.
5
Click Scan.
6
Follow the instructions on the computer screen.
Scanning color or black-and-white original
documents
1
Load an original document faceup into the Automatic Document Feeder (ADF) or facedown on the scanner glass.
Notes:
Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine
•
clippings) into the ADF. Place these items on the scanner glass.
Adjust the paper guide on the ADF tray to the width of the original document.
•
When using the scanner glass, close the top cover to avoid dark edges on the scanned image.
•
2
From the printer control panel, press
Scan to menu appears on the display.
3
Press the up or down arrow button to choose where to send the scanned image. You can send the scanned image
to a computer, flash drive, memory card, or to a computer over a network.
4
When the destination that you want is highlighted, press OK.
5
To scan black-and-white documents, press
Note: The default setting when you are using the Scan mode is Color. You do not need to press
are scanning a color document.
6
Press
.
Scanning photos for editing
1
Open the top cover, and then load an original document facedown on the scanner glass.
2
Close the top cover to avoid dark edges on the scanned image.
3
From the printer control panel, press
4
Press the up or down arrow button until Computer is highlighted, and then press OK.
Notes:
If you choose to send the scanned image to a computer over the network, press the left or right arrow button
•
until the computer name of the network computer appears, and then press OK.
You may be prompted to enter a PIN if the computer requires it. To assign a computer name and a PIN to the
•
network computer, see the Help for the printer software associated with your operating system.
If your printer has a numeric keypad, enter the PIN using the keypad, and then press OK.
•
If your printer does not have a numeric keypad, use the left or right arrow button to decrease or increase the
•
value for each digit (the default value is 0000) in the PIN, and then press OK each time you select a digit.
.
.
.
Scanning
91
if you