Table of Contents
Advertisement
4076-0XX
FRU OR PROCEDURE
5
Print Head Cable
6
Encoder Strip
Print Head Cable,
System Board
7
Maintenance Station
ACTION
Be sure connector J1 is fully seated.
Check the cable for damage.
Perform the
"Encoder Sensor Test" on
page
27. If you cannot enter the test,
replace the system board.
A problem with the maintenance sta-
tion can cause carrier movement
problems at the right margin. Go to
the
"Maintenance Station Service
Check" on page
12.
Diagnostic Information
23
- Quick Links:
- General Information
Hide quick links:
Advertisement
Table of Contents
