The Message "Epsonnet Config Cannot Be Used Because No Network Is Installed." Appears When You Start Epsonnet Config; The Message "Could Not Complete Communicating Configuration Data" Appears When You Send Settings To The Network Interface; Unable To Start Epsonnet Config With Web Browser - Epson 3250 Network Manual

The message "EpsonNet Config cannot be used because no network is
installed." appears when you start EpsonNet Config.
Cause
Both TCP/IP and IPX/SPX are not installed
on the computer.
TCP/IP is installed on the computer, but its
IP address is not set correctly.
The message "Could not complete communicating configuration data"
appears when you send settings to the network interface.
Cause
This may happen when using a dial-up
router.

Unable to start EpsonNet Config with Web Browser.

Cause
You have not set the IP address for the
network interface.
What to do
Install the TCP/IP or IPX/SPX protocol.
Set a correct IP address for the computer.
What to do
Run Command Prompt from the computer on which EpsonNet
Config is installed, and then enter the following command:
Format: >ROUTE_ADD_the IP address of the network interface_ the
IP address of the computer (the under bar represents one space)
Example: >ROUTE ADD 192.168.192.168 22.33.44.55.
What to do
Set the IP address for the network interface using EpsonNet Config
for Windows or Macintosh, the printer's control panel. You can check
the IP address on a status sheet. See the EpsonNet Config User's Guide.
EPSON Network Guide
Troubleshooting 116