Advertisement
2.
Press the WPS buttons of H560N and hold it down around 0.5 seconds, the LED will
Flash in Green with a 5Hz frequency.
3.
Press the WPS button of the existing router (Please refer to Figure1-1 ), Please note:
the Existing Router's setup has to be with No encryption and it's SSID (network name)
must be set to "visible".
4.
If the light is flashing green that means the configuration has succeeded. The SSID and
wireless password of H560N will be set to the same values as the Existing Router
automatically.
5.
If the Existing Router has no WPS button or if the light is flashing red (It means
configuration has failed), you can access H560N through the web (address is
192.168.1.253), to "Network"->"Wireless Extender" item to configure it manually.
5
Connect as Bridge/Router mode
1.
Switch AP/Extender slid to AP.
- 3 -
Hide quick links:
Advertisement
