Samsung AR09HSFSJWKN User & Installation Manual page 44

Connecting the wiring
1. Extend the assembly cable if necessary.
It may cause fire.
2 . Open the cover panel.
3 . Remove the screw securing the connector cover.
4 . Pass the assembly cable through the rear of the indoor unit and connect the assembly cable to terminals.
(Refer to the picture below)
5 . Pass the other end of the cable through the 2.56inch(65mm) hole in the wall.
6 . Close the connector cover by tightening the screw carefully.
7 . Close the cover panel.
8 . Remove the terminal board cover on the side of the outdoor unit.
9. Connect the cables to the terminals as seen in the picture.
Indoor unit
Indoor unit
Outdoor unit t
Outdoor unit
10. Connect the grounding conductor to the grounding terminals.
11. Close the terminal board cover by tightening the screw carefully.
installation.
(If they are loose, it could cause burn-out of the wires.)
AR5000&A3050 CV HP_IB&IM_DB68-04937A_EN.indd 44
09/12/18
L1 L2 F1 F2
L1 L2 F1 F2
F2
F1
L1 L2
English-44
24
Indoor unit
L3 L4 F1 F2
L3 L4 F1 F2
L3 L4 L1 L2
Outdoor unit
F1 F2
2015/1/4 11:48:15