Remote Control; General - Sharp LC-42LB261U User Manual

Problem Solution
No output from
• Adjust the audio balance. See
one of the
speakers.
• Make sure that the audio cables
After images
• Do not display a still image, such
appear.

Remote control

Problem Solution
Remote
• Make sure that the power cord is
control does
correctly connected to your TV and
not work.
a power outlet.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly at
the remote control sensor on your
TV. For the location of the remote
control sensor, see "Front" on
page 10.
• The supplied batteries are wrapped
tightly in clear plastic. Make sure
that you have removed this plastic
from the batteries.
• Make sure that the batteries are
installed correctly. See
remote control
page 38.
• Replace dead batteries with new
batteries. See
control

General

Problem Solution
No power.
• Make sure that the power cord is
correctly connected to your TV
and a power outlet.
• Unplug the power cord, wait 60
seconds, then plug the cord back
in and turn on your TV.
• Other devices (for example, a
surround sound receiver, external
speakers, fans, or hair dryers) may
be interfering with your TV. Try
turning off one device at a time to
determine which device is
causing interference. After you
have determined which device is
causing interference, move it
further from the TV to eliminate
the interference.
76
"Adjusting sound settings" on
page 55.
are connected correctly and
securely to your TV.
as a logo, game, or computer
image, for an extended period of
time. This can cause a permanent
after-image to be burned into the
screen. This type of damage is not
covered by your warranty.
"Installing
batteries" on
"Installing remote
batteries" on page 38.
LC-42LB261U/LC-50LB261U Sharp 42"/50" LED TV
Problem Solution
"No signal"
• Press INPUT and make sure that
error message is
you have selected the correct
displayed.
input for the device or service you
are trying to use.
• If you are using a cable or satellite
box, use the remote that came
with that box to change channels.
• Make sure that you have the
correct input selected to view
channels from the cable or
satellite box.
After Auto
• Reception can vary by channel
Channel Search,
depending on the broadcast
there are no
power level of a given station.
channels.
Contact your cable or satellite TV
provider.
• Make sure that the antenna or
cable/satellite TV is connected
securely to your TV.
• Try replacing the cable between
the antenna/cable or
cable/satellite box and your TV.
One or more
• Make sure that the channels are
channels do not
not blocked. See
display.
parental control
page 63.
• Make sure that the channels are
not hidden. The channel may
have been deleted from the
channel list. You can tune to the
channel by pressing the number
buttons or you can add the
channel back to the channel list.
See "Hiding
page 58.
• If you are using a cable or satellite
box, use the remote that came
with that box to change channels.
• Make sure that you have the
correct input selected to view
channels from the cable or
satellite box.
• If you are using an antenna, the
digital channel signal may be low.
To check the digital channel
signal strength, see
the digital signal
page 61.
Password is lost.
• Enter 9999 to access parental
controls, then set a new
password. See
changing the
page 61.
Some settings
• If a setting is grayed, the setting is
cannot be
not available in the current video
accessed.
input mode.
"Setting
levels" on
channels" on
"Checking
strength" on
"Setting or
password" on