Wolf IM15 Installation Manual page 11

Multi-Function Cooktop Installation
Install the Cooktop
GAS PRESSURE REGULATOR
Install the gas pressure regulator with the arrow on the
regulator pointing up toward the unit and in a position
where you can reach the access cap. Refer to the illustra-
tion below.
IMPORTANT NOTE: All connections must be wrench-tight-
ened. Do not make connections to the regulator too tight,
as this may crack the regulator and cause a gas leak. Do
not allow the regulator to turn on the pipe when tightening
fittings.
COOKTOP
ARROW
POINTS UP
ACCESS
CAP
Gas pressure regulator.
GAS SUPPLY CONNECTION
Assemble the flexible metal connector from the gas supply
pipe to the gas pressure regulator. You will need to deter-
mine the fittings required, depending on the size of your
gas supply line, flexible metal connector and shut-off
valve. Refer to the illustration below.
Use a pipe joint compound made for use with natural and
LP gas. If a flexible metal connector is used, be sure the
tubing is not kinked.
Open the gas shut-off valve in the gas supply line. Wait a
few minutes for the gas to move through the line. Refer to
the illustration on page 6.
GAS LEAK TESTING
Use a brush and liquid detergent to test all gas connec-
tions for leaks. Bubbles around connections will indicate a
leak. If a leak appears, shut off the gas supply and adjust
connections. Then check connections again. Clean the
detergent solution from the cooktop.
Never test for a gas leak with a match or other flame.
SHUT-OFF
VALVE
ADAPTER
NIPPLE
METAL CONNECTOR
wolfappliance.com/specs
GAS PRESSURE
REGULATOR
ADAPTER
FLEXIBLE NIPPLE
11