Table of Contents
Advertisement
LevelOne Broadband VPN Gateway User Guide
Connection Status - PPTP
If using PPTP (Peer-to-Peer Tunneling Protocol), a screen like the following example will be
displayed when the "Connection Details" button is clicked.
Data - PPTP Screen
Connection
Physical Address
IP Address
PPTP Status
Connection Log
Connection Log
Buttons
Connect
Disconnect
Figure 24: PPTP Status Screen
The hardware address of this device, as seen by remote devices on
the Internet. (This is different to the hardware address seen by
devices on the local LAN.)
The IP Address of this device, as seen by Internet users. This address
is allocated by your ISP (Internet Service Provider).
This indicates whether or not the connection is currently established.
If the connection does not exist, the "Connect" button can be
used to establish a connection.
If the connection currently exists, the "Disconnect" button can be
used to break the connection.
The Connection Log shows status messages relating to the
existing connection.
The "Clear Log" button will restart the Log, while the Refresh
button will update the messages shown on screen.
If not connected, establish a connection to your ISP.
If connected to your ISP, hang up the connection.
34
Advertisement
Table of Contents
