Precautions For Disassembly/(Re)Assembly; External Units And Imaging-Related Pcbs - Nikon D2X Repair Manual

Precautions for disassembly/(re)assembly

Notes： ① In disassembly/(re)assembly, be sure to use conductive mat (J5033) and wrist strap (J5033-5), in order to
protect electric parts from static electricity.
② Before disassmbling, be sure to remove batteries, AC power cord, and
③ In disassembling, be sure to memorize the processing state of wires and FPC, screws to be fixed and their
types, etc.
④ The low-pass filter of the image PCB is easily damaged. Handle it very carefully.
⑤ In the chapter of Disassembly, sometimes a large assembly unit is removed. In case such a unit is further
disassembled , refer to the exploded technical drawings.
⑥ In Disassembly/(re)assembly chapters, the dip-proof sponge is not mentined. In case parts are replaced, be
sure to attach the dip-proof sponge by referring to the exploded technical drawings.
⑦ All wires are special parts (supporting UL), so be sure to use specified wires.
Points to notice for Lead-free solder products
・Lead-free solder is used for this product.
・For soldering work, the special solder and soldering iron are required.
・Do NOT mix up lead-free solder with traditional solder.
・Use the special soldering iron respectively for lead-free solder and lead solder. They
cannot be used in common.
Disassembly

1. External units and Imaging-related PCBs

Note 1: Before disassembling a camera, of which the main FPC should be replaced, be sure to read and note down the
adjustment value of the environment light sensor by adjustment software for the camera unit. If the value cannot be
read out from the camera, replace the top cover unit, too. (Refer to Page A28 for the details when replaced.)
Note 2: When "Seprating Front and Rear bodies", "Disassembling Image PCB", and "Disassembling Bayonet", be sure to perform
"Reset of AF defocus compensation amount" by D2X adjustment software after reassembly.
External rubber
・ Remove the grip rubber (#B60-1), apron lower rubber (#B66), and rubber at the film rewind side (#B61).
#729
#B60-1
- Ｄ1 ･ -
VBA10501-R.3657.A
battery for clock (CR1616).
#B61
#B66