Automatic Sensor Cleaning - Canon EOS 700D Instruction Manual

f Automatic Sensor Cleaning
Whenever you set the power switch to <1> or <2>, the Self
Cleaning Sensor Unit operates to automatically shake off the dust on
the front of the sensor. Normally, you need not pay attention to this
operation. However, you can choose to perform sensor cleaning at any
time, or disable it.
Cleaning the Sensor Now
For best results, perform the sensor cleaning with the camera pla For best results, perform the sensor cleaning with the camera placed For best results, perform the sensor cleaning with the camera pla
upright and stable on a table or other flat surface.
Even if you repeat the sensor cleaning, the result will not improve much.
Immediately after the sensor cleaning is finished, the [Clean now
option will remain disabled temporarily.
Disabling Automatic Sensor Cleaning
In step 2, select [Auto cleaningf] and set it to [Disable].
The sensor cleaning will no longer be executed when you set the
power switch to <1> or <2>.
1
Select [Sensor cleaning].
Under the [53] tab, select [Sensor
cleaning], then press <0>.
2
Select [Clean now Select [Clean now Select [Clean now
Select Select [ Select [Clean nowf], then press [Clean now Clean now
0 0
<0>. >. >.
Select [ Select [OK] on the dialog screen, Select [
then press < then press < then press <0>.
The screen will indicate that the
sensor is being cleaned. (A small
sound may be heard.) Although there
will be a shutter sound during the
cleaning, a picture is not taken.
], then press < ], then press <
].
f
f
]
223