Managed Access Point; Table 9: Managed Access Point Commands - D-Link DWL-8600Ap Reference Manual

Action
Set the Fragmentation Length Threshold
Set the RTS Threshold
Set the maximum number of clients allowed to
associate (VAP 0 radio 0)
Set the power transmission level (percent)
Set the fixed multicast rate
Add a basic rate set
Get current basic rates
Add supported rate
Get current supported rates
Enable or disable broadcast/multicast rate limiting
Set the rate limit (packets per second)
Set the rate limit burst (packets per second)
Set the STBC
Set the Short Guard Interval
Note:
M A
ANAGED CCESS
You can use a D-Link Wireless Switch to manage one or more access points on your network. To allow a switch to manage
the AP the switch and AP must discover each other. The commands in
Standalone to Managed and how to configure the IP address of a D-Link Wireless Switch so that the AP can discover it. You
can configure a pass phrase on the AP and on the switch so that only authenticated APs can associate with the switch.
Action
View Managed AP settings
Set the AP to Managed mode
Set the AP to Standalone mode
Set the pass phrase for AP-to-switch
authentication
Table 8: Radio Settings Commands (Cont.)
Command
set radio wlan0 fragmentation-threshold <256-
2346>
set radio wlan0 rts-threshold <0-2347>
set bss wlan0bssvap0 max-stations <0-200>
set radio wlan0 tx-power <0-100>
set radio wlan0 fixed-multicast-rate {54 | 48 |36
|24 | 18 | 12 |9 | 6 | auto}
add basic-rate wlan0 rate integer
get basic-rate
add supported-rate wlan0 rate integer
get supported-rate wlan0
set radio wlan0 rate-limit-enable {on | off}
set radio wlan0 rate-limit <limit>
set radio wlan0 rate-limit-burst <limit>
set radio wlan0 stbc-mode {on | off}
set radio wlan0 short-guard-interval-supported
{yes | no}
P
OINT

Table 9: Managed Access Point Commands

Command
get managed-ap
set managed-ap mode up
set managed-ap mode down
set managed-ap pass-phrase <password>
Note: The password you enter must match the local authentication password you
configure for Valid APs on the D-Link Wireless Switch.
To remove the password, enter the command without the password variable.
Access Point CLI Commands
Table 9 show how to change the AP mode from
17