Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes From Motor Unit Memory; 3-Function Remotes - Craftsman 139.18405D Owner's Manual

PROGRAMMING

NOTICE: If this Security ✚ ®
of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in
the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will open
and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
USING THE "LEARN" BUTTON
1. Press and release the "learn" button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.

To Erase All Codes From Motor Unit Memory

To deactivate any unwanted remote, fi rst erase
all codes:
Press and hold the purple "learn" button on
motor unit until the learn indicator light goes
out (approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
garage door opener is operated with a non-rolling code transmitter, the technical measure in the receiver

To Add or Reprogram a Hand-held Remote Control

® 315 MHz remote controls.
USING THE DOOR CONTROL
1. Press the Learn button on the door control.
2. Press the Learn button again to confi rm
Learn Mode.
3. Press the button on the hand-held remote*
that you wish to operate your garage door.
4. When the motor unit lights blink, it has
learned the code. If light bulbs are not
installed, two clicks will be heard.
*3-Function Remotes (315 MHz)
If provided with your garage
door opener, the large button
is factory programmed to
operate it. Additional buttons
on any Security✚ ® 3-Function
remote or compact remote can
be programmed to operate
other Security✚ ® garage door
openers.
37