Using The Wall-Mounted Door Control - Craftsman 139.18405D Owner's Manual

Using the Wall-Mounted Door Control

THE SMART CONTROL PANEL
Press the push bar to open
or close the door. Press
again to reverse the door
during the closing cycle or
to stop the door while it's
opening.
This door control contains
a motion detector that
will automatically turn on
the light when it detects a
person entering the garage.
This feature can be easily
turned off for extended work light use.
LIGHT
Light Feature
Press the Light button to turn the opener light on or off. It will
not control the opener lights when the door is in motion. If you
turn it on and then activate the opener, the light will remain on
for 4-1/2 minutes. Press again to turn it off sooner. The 4-1/2
minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes
as follows: Press and hold the Lock button until the light blinks
(about 10 seconds). A single blink indicates that the timer is reset
to 1-1/2 minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat again for a
3-1/2 minute interval, etc., up to a maximum of four blinks and
4-1/2 minutes.
When using the opener lights as working lights, we recommend
that you fi rst disable the motion sensor.
LOCK
Lock Feature
Designed to prevent operation of the door from hand-held remote
controls. However, the door will open and close from the door
control or the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds. The
push bar light will fl ash as long as the Lock feature is on.
To turn off, press and hold the Lock button again for 2 seconds.
The push bar light will stop fl ashing. The Lock feature will also turn
off whenever the "learn" button is activated.
Motion Detecting Light Feature: The opener light will turn on
automatically when a person walks in front of the wall-mounted
door control. This feature works by detecting motion and body
heat and may not work in temperatures around 100˚ F, 37.7˚ C. The
opener light will come on for 5 minutes, then shut off automatically
if no additional motion or heat differential is calculated.
To disable this feature, press the Automatic Light On/Off
button on the left side of the door control.
We recommend that you disable the motion sensor when
using the opener lights as working lights. Otherwise, they
will turn off automatically if you are working beyond the
sensor's range.
®
Motion Detecting
Light On/Off
Prog <Learn>
Hour
Minute
Language
Degrees (F/C)
Lock Button
PROG <Learn> Feature
The door control is equipped with a PROG <LEARN> button to
Push Bar
assist in learning remote controls to the unit. Press the PROG
<LEARN> button once to initiate LEARN mode and the display
will show 'Learn Remote Control - Press Learn Button Again to
Confi rm.' Press the PROG <LEARN> button a second time and
the display will show 'Learn Mode - Press Remote Control Button
to Learn Remote.' Press the button of the remote control to be
learned and the worklight will blink to confi rm the remote control
Light Button
has been learned.
H M
Hour and Minute Feature
Press or hold either of these side buttons to increment the hour or
minute displayed on the LCD display.
<LANG> Language Feature
Press this side button to toggle between the three languages -
English, Spanish, and French.
Degrees F/C Feature
Press this side button to toggle the temperature units between
Fahrenheit and Celsius.
Additional feature when used with the
3-Function hand-held remote
To control the opener lights:
1. With the door closed, press and hold a small
remote button that you want to control the light.
2. Press and hold the Light button on the door control.
3. While holding the Light button, press and hold the Lock button
on the door control.
4. After the opener lights fl ash, release all buttons.
31