Bosch SHE55P Repair Manual page 8

While pushing (and holding) any two wash cycle buttons, turn the
dishwasher on with the on/off switch. The current coding (e.g.
"C1") will show in the display or LED's until you release the
buttons. After releasing the buttons, LED "B" will be lit and LED
"C" will flash, confirming you're in the special programs menu.
Push button "B" repeatedly until you've selected your desired
program (see P(X) Program codes, "P1" or "P4" -- programs "P0"
and "P3" are factory tests that aren't to be used).
The following typical codes cover most dishwashers. Consult the
test program for your model to confirm the codes to use.
3.4.1 Typical P(X) Program codes
P0 = Functional test - used for assembly (do not use)
P1 = Customer service test program (see E(X) error codes)
P3 = Endurance / Life test (do not use)
P4 = Control coding (see C(X) control codes)
3.4.2 Typical E(X) Error codes
E0 = No errors
E1 = Heating error
E2 = NTC error
E3 = Filling error
E4 = Water switch cannot be positioned
E5 = Safety float water level reached or motor speed error (error
code dependent on model – check test program)
E6 = Aqua sensor error
3.4.3 Typical C(X) Control codes
C9 = Sales demo mode
Codes C1 through C9 are possible, depending on the model.
HINT: Customers pushing and holding Cancel-Drain or Cancel-
Reset buttons while turning dishwashers on can see strange
702_58300000148618_ara_en_a
displays. Whenever you get call about a "strange" display, check
if the customer put the dishwasher into the test program or some
other program.
3.4.4 Sales demo (showroom) program
3.4.4.1 Entering sales demo program
Enter the special program mode – see section 3.5.
releasing the two buttons held while you turned the dishwasher
on, note the coding on the digital display (e.g. "C1", "C2", etc) --
the dishwasher must be returned to this code for resale.
Push button "B" repeatedly until the display shows sales demo
program mode "P4". Push button "C" to confirm it.
Push button "B" repeatedly until the display shows sales demo
code "C9". Push button "C" to confirm it.
Turn power off and then back on. The dishwasher is now in
demo mode -- all button lights will light up.
3.4.4.2 Preparing a dishwasher for showroom use
1. Turn off the power to the dishwasher or disconnect the
dishwasher from the electrical power.
m
WARNING: Danger of electrical shock!
2. Remove the toe kick and locate the drain pump terminal
shown below. Disconnect the terminal from the drain
pump by squeezing and pulling it out. Cover the terminal
with electrical tape to prevent electrical shock.
Before
Page 8 of 42