Battery Installation - Power Wheels Jeep Wrangler Owner's Manual

H
IMPORTANT! Use only a Power Wheels
Use of any other battery will damage your vehicle. Make
sure that you charge the battery for at least 18 hours using
the enclosed Power Wheels
operating your vehicle for the first time. Charge the battery
for at least 14 hours after each use of the vehicle. Never
charge the battery longer than 30 hours. Failure to follow
these instructions may damage your battery and will void
your warranty. It is easier to install the battery before
assembling the hood to your vehicle. If you have already
assembled the hood to your vehicle, you may want to
remove it to install the battery.
1
Hood
Battery
Compartment
• Lift the hood to access the battery compartment.
2
Battery
Compartment
• Press the battery clamp to slide it into the dash
• While holding the battery clamp against the dash, place
the battery in the battery compartment
battery is upright and positioned between the locator ribs
at the bottom of the battery compartment.

Battery Installation

® 12 volt battery.
® 12 volt charger before
Battery
Clamp
2
1
Locator
Ribs
.
. Make sure the
3
Battery
Compartment
• Release the battery clamp. Make sure the battery clamp
slides over the top of the battery. If the battery clamp
does not slide over the top of the battery, reposition the
battery in the battery compartment. (See step 2.)
4
Battery
• Plug the motor harness connector into the battery.
Push firmly to make sure the connectors are
completely joined.
Note: To remove a battery from the battery compartment,
disconnect the motor harness connector from the battery.
Press and hold the battery clamp against the dash and
lift the battery from the battery compartment.
23
Battery
Battery
Clamp
Motor
Harness
Connector