Lenovo THINKCENTRE 5068 Hardware Maintenance Manual page 75
Machine types: 5068, 7558, and 7567
Hide thumbs
Also See for THINKCENTRE 5068:
- Maintenance manual (144 pages) ,
- Hardware maintenance manual (180 pages) ,
- User manual (138 pages)
Table of Contents
Advertisement
Diagnostic Error Code
014-197-XXX Parallel port test warning
014-198-XXX Parallel port test aborted
014-199-XXX Parallel port test failed, cause unknown
014-2XX-XXX 014-3XX-XXX Parallel port failure
015-000-XXX USB port Interface Test Passed
015-001-XXX USB port Presence
015-002-XXX USB port Timeout
015-015-XXX USB port External Loopback failure
015-027-XXX USB port Configuration/Setup error
015-032-XXX USB port Device Controller failure
015-034-XXX USB port buffer allocation failure
015-035-XXX USB port Reset condition detected
015-036-XXX USB port Register error
015-040-XXX USB port IRQ failure
015-195-XXX USB port Test aborted by user
FRU/Action
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility program" on page 57.
2. Re-run test.
3. Replace the component that is called out in warning
statement.
4. Replace the component under test.
1. If a component is called out, make sure it is
connected and/or enabled.
2. Flash the system and re-test. See "Flash update
procedures" on page 167.
3. Go to "Undetermined problems" on page 82.
1. Go to "Undetermined problems" on page 82.
2. Flash the system and re-test. See "Flash update
procedures" on page 167.
3. Replace component under function test.
1. External parallel device
2. System board
No action
1. Remove USB device(s) and re-test.
2. System board
1. Remove USB device(s) and re-test.
2. System board
1. Remove USB device(s) and re-test.
2. System board
1. Flash the system. See "Flash update procedures"
on page 167.
2. System board
System board
1. Reboot the system
2. Flash the system and re-test. See "Flash update
procedures" on page 167.
3. Run memory test.
4. System board
1. Remove USB device(s) and re-test.
2. System board
System board
1. Run the Setup Utility program and check for
conflicts.
2. Flash the system. See "Flash update procedures"
on page 167.
3. System board
Information only Restart the test, if necessary.
Chapter 7
.
Symptom-to-FRU Index
69
Advertisement
Table of Contents
Troubleshooting
