Replacing The System Board - Lenovo THINKCENTRE 5068 Hardware Maintenance Manual

10. Route the new integrated camera cable, and then connect the integrated camera cable to the system
board. See "System board parts and connectors" on page 88.
11. Reinstall the system board shield. See "Removing and reinstalling the system board shield" on page 102.
12. Go to "Completing the parts replacement" on page 125.

Replacing the system board

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety
information" in the ThinkCentre Edge Safety and Warranty Guide that came with your computer. To obtain a
copy of the ThinkCentre Edge Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the system board.
To replace the system board, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or other flat surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See "Removing the computer cover" on page 95.
4. Remove the system board shield. See "Removing and reinstalling the system board shield" on page 102.
5. Locate the system board in the computer. See "FRU locations" on page 86.
6. Remove the heat sink assembly. See "Replacing the heat sink assembly" on page 105.
7. Remove the microprocessor. See "Replacing the microprocessor" on page 107.
8. Remove the memory modules. See "Installing or replacing a memory module" on page 114.
9. Remove the battery. See "Replacing the battery" on page 112.
10. Remove the rear I/O assembly to gain access to the system board. See "Replacing the rear I/O
assembly" on page 100.
11. Note the locations of all cable connections on the system board and disconnect all cables. See "System
board parts and connectors" on page 88.
12. Remove the seven screws that secure the system board to the main bracket. Carefully lift the system
board out of the chassis.
118
ThinkCentre Edge Hardware Maintenance Manual