Replacing An Optical Drive; Replacing The Media Card Reader - Lenovo E200 Hardware Maintenance Manual

Replacing an optical drive

1. Remove the computer cover. See "Removing the computer cover" on page 86.
2. Remove the front bezel. See "Removing and replacing the front bezel" on page
3. Disconnect the power cable and signal cable from the optical drive.
4. Remove the two screws that secure the optical drive in the drive bay.
5. Slide the optical drive outward until remove it out of the drive bay.
6. If the drive you are replacing has jumpers on the rear, make sure the jumpers
7. Slide the new drive into the drive bay until the screws holes on each side are
8. Reconnect the power cable and signal cable to the new optical drive.
9. Go to "Completing the FRU replacement" on page 107.

Replacing the Media Card Reader

This section provides instructions on how to replace the Media Card Reader.
1. Open the front bezel. See "Removing and replacing the front bezel" on page 88.
2. Locate the Media Card Reader. See "Locations" on page 84
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
88.
on the new drive are in the same exact position as the drive being replaced.
aligned and install two screws in each side of the drive.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
Chapter 8. Replacing FRUs (Type 7848)
105