For Your Safety Read Before Lighting - Superior DRT2033 Installation And Operation Instructions Manual

Innovative Hearth Products
Superior™ DRT2000 and DRC2000 Direct-Vent Gas Fireplaces
Electronic Gas Valve
WARNING: If you do not follow these instructions exactly, a fire or explosion may result,
causing property damage, personal injury, or loss of life.
A.
This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by hand.
B.
BEFORE OPERATING smell all around the appliance area for gas. Be
sure to smell next to the floor because some gas is heavier than air
and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch; do not use any phone in your building.
Immediately call your gas supplier from a neighbor's phone. Follow the
gas supplier's instructions.
If you cannot reach your gas supplier, call the fire department.
1.
STOP! Read the safety information above on this label.
2.
Read the Care and Operation manual including the section on
"Remote Control System," (if applicable).
3.
Slide the switch on the receiver, wall switch or ON/OFF switch to OFF.
4.
Turn OFF all electric power to the appliance.
NOTE: The control may have a battery backup (remove batteries,
5.
This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by hand.
6.
Wait five (5) minutes to clear out any gas. If you then smell gas,
STOP! Follow B in the safety information above on this page. If you
do not smell gas, go to the next step.
7.
Turn on all electric power to the appliance.
NOTE: The control may have a battery backup (install batteries, if applicable).
8.
Slide the switch on the receiver to REMOTE or ON/OFF switch / wall
switch to ON.
9.
(if applicable) Press ON/OFF button on remote control transmitter to ON.
10.
(if applicable) Set thermostat on remote control to desired setting.
11.
If the appliance will not operate, follow the instructions "To Turn Off
Gas To Appliance" and call your service technician or gas supplier.
1.
Slide the switch on the receiver, wall switch or ON/OFF switch to OFF.
2.
(if applicable) Press ON/OFF button on remote control transmitter
to OFF.
66

FOR YOUR SAFETY READ BEFORE LIGHTING

LIGHTING INSTRUCTIONS
if installed).
TO TURN OFF GAS TO APPLIANCE
WARNING
Hot glass will cause burns.
Do not touch glass until cooled.
Never allow children to touch glass.
C.
If any portion of this appliance does not operate as the instructions
indicate, do not try to repair it, call a qualified service technician.
Do not use tools. Force or attempted repair may result in a fire
or explosion.
D.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
Electronic Gas Control
Valve—SIT
Electronic gas control valve
Electronic Pilot Assembly
Electronic pilot assembly
3.
Turn off all electric power to the appliance if service is to be
performed.
NOTE: The control may have a battery backup (remove batteries, if installed).
4.
Close the main line gas shut-off valve.
Operation
900004-00, 04/2014