Miscellaneous Error Messages - Lenovo THINKSERVER 1008 Hardware Maintenance Manual

Table 2. ThinkServer EasyStartup DVD (continued)
• Follow the suggested actions in the order in which they are listed in the Action column until the problem
is resolved.
• See the Chapter 7 "Parts Listing, TS200v Machine Types 0981, 0992, 1008, and 1010" on page 59 to
determine which components are customer replaceable units (CRUs) and which components are field
replaceable units (FRUs).
Symptom
The EasyStartup
program will not start
the operating-system
medium.

Miscellaneous error messages

Message/Symptom
Changing display colors
Computer will not power-off. See "Hard disk drive boot
error" on page 16.
Computer will not RPL from server
Computer will not perform a Wake On LAN® (if applicable)
Dead computer. See "Hard disk drive boot error" on page
16.
Diskette drive in-use light remains on or does not light
when drive is active.
Blank screen except for flashing cursor.
Incorrect memory size during POST
Action
Make sure that the operating-system medium is supported by the EasyStartup program.
See the EasyStartup User Guide for a list of supported operating-system versions. The
EasyStartup User Guide and compatibility notes are available through the EasyStartup
program.
FRU/Action
Display/Monitor
1. Power Switch
2. System Board
3. Riser card, if installed.
1. Ensure that network is in startup sequence as first
device or first device after diskette.
2. Ensure that network adapter is enabled for RPL.
3. Network adapter (Advise network administrator of
new MAC address)
1. Check power supply and signal cable connections
to network adapter.
2. Ensure that the operating system settings are set to
enable Wake on LAN.
3. Ensure Wake On LAN feature is enabled in
Setup/Configuration (see "Starting the Setup Utility
program" on page 77)
4. Ensure network administrator is using correct MAC
address.
5. Ensure no interrupt or I/O address conflicts.
6. Network adapter (advise network administrator of
new MAC address)
1. Power Supply
2. System Board
1. Diskette Drive
2. System Board
3. Diskette Drive Cable
1. System Board
2. Primary Hard Disk Drive
3. Hard Disk Drive Cable
1. Run the Memory tests.
2. Memory Module
3. System Board
19
.
Chapter 4 Diagnostics