Safety Instructions For Connecting Electricity; Save These Instructions - LG GD1329CGS Service Manual

READ ALL INSTRUCTIONS BEFORE USE
WARNING
of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life.

SAFETY INSTRUCTIONS FOR CONNECTING ELECTRICITY

WARNING:
appliance, follow basic precautions, including the following:
• Do not, under any circumstances, cut or
remove the ground prong from the power cord.
To prevent personal injury or damage to the dryer,
the electrical power cord must be plugged into a
properly grounded outlet.
• For personal safety, this dryer must be
properly grounded. Failure to do so can result in
electrical shock or injury.
• Refer to the installation instructions in this
manual for specific electrical requirements for
your model. Failure to follow these instructions
can create an electrical shock hazard and/or a fire
hazard.
• This dryer must be plugged into a properly
grounded outlet. Electrical shock can result if
the dryer is not properly grounded. Have the
wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly
grounded. Failure to follow these instructions can
create an electrical shock hazard and/or a fire
hazard.
• The dryer should always be plugged into its
own individual electrical outlet which has a
voltage rating that matches the rating plate.
This provides the best performance and also
prevents overloading house wiring circuits which
could cause a fire hazard from overheated wires.
For your safety, the information in this manual must be followed to minimize the risk
To reduce the risk of fire, electric shock, or injury to persons when using this

SAVE THESE INSTRUCTIONS

• Never unplug your dryer by pulling on the
power cord. Always grip plug firmly and pull
straight out from the outlet. The power cord can
be damaged, resulting in a risk of fire and
electrical shock.
• Repair or replace immediately all power cords
that have become frayed or otherwise
damaged. Do not use a cord that shows cracks
or abrasion damage along its length or at
either end. The power cord can melt, creating
electrical shock and/or fire hazard.
• When installing or moving the dryer, be careful
not to pinch, crush, or damage the power cord.
This will prevent injury and prevent damage to the
dryer from fire and electrical shock.
• To reduce the risk of personal injury, adhere to
all industry recommended safety procedures
including the use of long sleeved gloves and
safety glasses. Failure to follow all of the safety
warnings in this manual could result in property
damage, personal injury or death.
• Connect the power cord to the terminal block.
Each colored wire should be connected to
same color screw. Wire color indicated on
manual is connected to the same color screw
in block. Failure to follow these instructions may
result in a short or overload.
8