Placing A Photo Or Document On The Document Table - Epson Stylus Photo RX620 series Basic Operation Manual

4. Stand the stack of paper against the paper
support and slide the left edge guide so that it
meets the left edge of the paper.
Note:
❏ Always load paper into the sheet feeder's short
edge first.
❏ Make sure the paper is loaded under the tabs
inside the edge guides, and is flush with, or lower
than the triangular load-limit mark on the edge
guide.
5. Set the feeder guard back.
Note:
❏ The loading capacity differs depending on the
following types of paper.
Paper Type Paper Type Settings
Plain Paper Plain
EPSON Bright White Bright White
Ink Jet Paper
EPSON Photo PQIJ
Quality Ink Jet Paper
EPSON Photo Paper Photo Paper
EPSON Matte Matte
Paper-Heavyweight
EPSON Premium Prem. Glossy
Glossy Photo Paper
EPSON Premium SemiGloss
Semigloss Photo
Paper
EPSON Iron-On Cool Iron On
Peel Transfer Paper (only for copying)
EPSON Photo Photo Stickers
Stickers (only when printing
from a memory card)
6
Copying
❏ You cannot use Plain Paper when Borderless has been
selected in the Copy Layout.
Placing a Photo or Document on
the Document Table
1. Open the document cover. Place the original
document facing down on the document table.
Make sure that the document is properly
aligned.
c
Note:
An area of up to 2.5 mm from the edge of the document
table glass cannot be copied.
Loading
Capacity
Up to 100
sheets
Up to 80
sheets
2. Make sure the reflective document mat is
attached to the document cover.
3. Close the document cover gently so that the
One sheet
at a time
document does not move.
Up to 20
Note:
sheets
To copy the document properly, close the document
cover to prevent interference from the external light.
One sheet
at a time
Caution:
Never open the document cover beyond its
limit by intention.
2.5 mm (max)
2.5 mm (max)