Lenovo THINKCENTRE 6393 Hardware Maintenance Manual page 58

Diagnostic Error Code
025-02X-XXX 025-03X-XXX 025-04X-XXX IDE Interface
failure
025-195-XXX IDE interface Test aborted by user
025-196-XXX IDE interface test halt, error threshold
exceeded
025-197-XXX IDE interface test warning
025-198-XXX IDE interface test aborted
025-199-XXX IDE interface test failed, cause unknown
030-000-XXX SCSI interface Test Passed
030-00X-XXX 030-01X-XXX SCSI interface failure
030-027-XXX SCSI interface Configuration/Setup error
030-03X-XXX 030-04X-XXX SCSI interface error
52
Hardware Maintenance Manual
FRU/Action
1. IDE signal cable
2. Check AC/DC power adapter
3. Reseat IDE signal cable
4. IDE device
5. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6
"Diagnostics, Test and Recovery Information" on
page 39
2. Flash the system and re-test. See "Updating (flashing)
BIOS from a CD-ROM or diskette" on page 139
3. Go to "Undetermined problems" on page 62
1. Go to "Undetermined problems" on page 62
2. Flash the system and re-test. See "Updating (flashing)
BIOS from a CD-ROM or diskette" on page 139
3. Replace component under function test
No action
1. SCSI signal cable
2. Check AC/DC power adapter
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Flash the system. See "Updating (flashing) BIOS from
a CD-ROM or diskette" on page 139
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Check AC/DC power adapter
3. SCSI device
4. SCSI adapter card, if installed
5. System board