Lenovo THINKCENTRE 6393 Hardware Maintenance Manual page 55

Diagnostic Error Code
006-197-XXX Diskette interface test warning
006-198-XXX Diskette interface test aborted
006-199-XXX Diskette interface test failed, cause
unknown
006-25X-XXX Diskette interface Error
015-000-XXX USB port Interface Test Passed
015-001-XXX USB port Presence
015-002-XXX USB port Timeout
015-015-XXX USB port External Loopback failure
015-027-XXX USB port Configuration/Setup error
015-032-XXX USB port Device Controller failure
015-034-XXX USB port buffer allocation failure
015-035-XXX USB port Reset condition detected
015-036-XXX USB port Register error
015-040-XXX USB port IRQ failure
015-195-XXX USB port Test aborted by user
015-196-XXX USB port test halt, error threshold exceeded
FRU/Action
1. If a component is called out, make sure it is
connected and/or enabled
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test. See "Updating (flashing)
BIOS from a CD-ROM or diskette" on page 139
3. Go to "Undetermined problems" on page 62
1. Go to "Undetermined problems" on page 62
2. Flash the system and re-test
3. Replace component under function test
1. Diskette drive cable
2. Diskette drive
3. System board
No action
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a CD-ROM or diskette" on page 139
2. System board
System board
1. Reboot the system
2. Flash the system and re-test. See "Updating (flashing)
BIOS from a CD-ROM or diskette" on page 139
3. Run memory test
4. System board
1. Remove USB device(s) and re-test
2. System board
System board
1. Run setup and check for conflicts
2. Flash the system. See "Updating (flashing) BIOS from
a CD-ROM or diskette" on page 139
3. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
Chapter 7
.
Symptom-to-FRU Index
49