Lenovo 3425 Hardware Maintenance Manual page 56

Diagnostic error code
005-031-XXX Video device cable failure
005-032-XXX Video device controller failure
005-036-XXX Video register error
005-038-XXX System BIOS extension failure
005-040-XXX Video IRQ failure
005-195-XXX Video test aborted by user
005-196-XXX Video test halt, error threshold exceeded
005-197-XXX Video test warning
005-198-XXX Video test aborted
005-199-XXX Video test failed, cause unknown
005-2XX-XXX 005-3XX-XXX Video subsystem error
006-000-XXX Diskette interface Test Passed
006-0XX-XXX Diskette interface error
006-195-XXX Diskette interface Test aborted by user
006-196-XXX Diskette interface test halt, error threshold
exceeded
50
Hardware Maintenance Manual
FRU/Action
1. Video cable
2. Monitor
3. Video card, if installed
4. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Re-run test
3. Replace the component called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility" on page 41
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 99
3. Go to "Undetermined problems" on page 64
1. Go to "Undetermined problems" on page 64
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 99
3. Replace component under function test
1. Video card, if installed
2. System board
No action
1. Diskette drive Cable
2. Diskette drive
3. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file