Sony DWR-R02D User Manual page 32

The frequency bands that appear are identical to those
that can be selected for the receiver's BAND setting.
In the steps that follow, the channel plan can only be
selected from the bands selected here.
3
Specify any TV channels, and click "Next >."
You can specify TV channels by placing check marks
in the list.
The specified TV channels will be plotted in the
frequency spectrum display area.
The TV broadcast waves selected here will be
classified as interference, and the respective
frequencies will be removed from the candidates
available during channel plan selection.
4
Specify any frequencies used by other wireless
devices, and click "Next >."
Specify the frequencies assigned to other wireless
devices being used in the same area.
The frequencies selected here will be classified as
interference and removed from the candidates
available during channel plan selection.
The specified frequencies will be plotted in the
frequency spectrum display area.
To add frequencies
Enter the frequency (MHz), and click the "Add"
button.
You can use one of the following methods to add
frequencies.
Single Frequency: Adds the frequency entered in the
text box.
Multi-Frequency at equal intervals: Adds all the
frequencies between the frequencies entered for
"From" and "To" at the interval specified in
"Interval."
32
Setup Windows
To remove frequencies
Remove: Removes the frequency selected in the list.
Remove All: Removes all the frequencies in the list.
5
Perform channel scan, and click "Next >."
Frequencies that are likely to be interference are
detected by the receiver's channel scan function.
The detected frequencies will be plotted in the
frequency spectrum display area.
To specify the receiver that will perform the
scan
Select the receiver that will perform the frequency
band scan.
If you select "Do not scan" instead of a receiver,
channel scan will not be performed for that frequency
band.
To adjust scan conditions
Repeat count: Specify the number of times to repeat
the scan. You can specify a number from 1 to 10.
Frequency Interval: Specify the frequency interval.
You can specify an interval of 125 kHz or 25 kHz.
Detect threshold Level: Specify an RF level to use as
a threshold for determining interference. You can
specify a level from 5 to 30 dBuVemf in 1 dB steps.
Note
Receiver models manufactured for use in Japan cannot
perform scanning at 25 kHz intervals.
To start scanning
Click "Start scan."
Scanning starts. When scanning is complete, the
results of the previous scan will be removed and
updated with the new results.
If the "Sleep transmitters while scanning" check box is
selected, any transmitters that can be controlled
remotely will be automatically set to sleep mode
during the scan.
To clear scan results
Click "Clear."
The scan results up to this point will be cleared.
6
Specify conditions for avoiding interference, and click
"Next >."