Basic Operations; Device Detection And Monitoring - Sony DWR-R02D User Manual

Basic Operations

Wireless Studio operates in one of two modes, online
mode and offline mode.
Online mode
Online mode is used to enable real-time communication
between the receivers and RMU-01 units via the network,
and allow monitoring and control of the devices.
Device Detection and Monitoring (page 11)
Locate the receivers and RMU-01 units on the network, and
enable monitoring for these devices. This operation is
necessary for the pairing and device control operations that
follow.
Selecting Channel Plans (page 13)
Scan the signal environment using the channel scan
function of the receiver, and view the results while selecting
the channel plan.
Pairing Receiver Channels and Transmitters (page 14)
Pairing is necessary to enable control of the transmitters via
wireless remote control. Use the pairing wizard in Wireless
Studio to pair receivers and transmitters.
Controlling Devices (page 15)
Perform device controls from the Property window and the
Property List tab of the sub window.
Recording the Signal Environment during Operation
(page 17)
Record the signal levels and changes in QL for each
receiver. Warnings related to signal reception and QL will
also be recorded.
Offline mode
Offline mode is used for settings file operations (saving,
recalling, etc.), and applying the settings displayed in
Wireless Studio to all devices simultaneously.
Using Settings Files (page 17)
Setting values for receivers and transmitters can be saved
as files. You can recall previously used setting values by
opening a stored settings file and applying it to the devices.
r
r
r
r

Device Detection and Monitoring

1
Select "Start > All Programs > Sony > Digital Wireless
Microphone System > Wireless Studio" to start up the
software.
2
Place a check mark next to "Online monitoring and
control" in the Device menu.
The system enters online mode, and the receivers and
RMU-01 units are automatically detected and added to
the device list window.
Receivers that are added to the device list are
automatically registered to the "All tuners" page of the
status viewer where they can then be monitored.
For more information on window contents, see "Status
Viewer and Meter Icons" on page 21.
Note
The Windows firewall or your security software's
firewall may prevent devices from being detected
automatically. If the devices are not detected
automatically, disable the firewall settings.
To monitor a particular set of receiver channels
Display a page in the status viewer other than the "All
tuners" page, and register receiver channels manually to
monitor only the receiver channels that you select.
To display a receiver channel in the status viewer, drag the
receiver channel selected in the device list and drop it in
the status viewer, or right-click the receiver channel and
select "Add to Status Viewer" in the context menu that
appears.
Click [+] to the
left of a receiver
icon to display
the receiver
channels.
11
Basic Operations