Daewoo DLP-2612 Service Manual page 29

To adjust WHITE BALANCE, refer to below process.
A. To enter Service Mode, press button S1(when Service Remocon) or Adjust Sharpness
¡° 0¡±in Picture mode =>Adjust PR ¡° 99¡± => Press the ¡° Red¡± , ¡° Green¡±and ¡° Blue¡±Button
=> Press the ¡° menu¡±button.(when User Remocon)
Then, HEAT RUN MODE IS CANCLED.
-HEATRUN =1 : ON
-HEATRUN =0 : OFF
B. Attach a sensor of White Balance Meter to center on the screen.
C. Press S8(8), Then the set is entered TV WHITE BALANCE Adjustment Mode.
D. Middle BEAM(330~270cd): Adjust WHITE BALANCE by varying Gain of R,B(G fixed)
-Coordinate of color is X=273 ¡¾5, Y=280 ¡¾5 And press menu key to change middle
beam pattern.
E. Low BEAM(60~20cd): Adjust WHITE BALANCE by varying OFFSET R,B(G fixed)
-Coordinate of color is X=273 ¡¾5, Y=280 ¡¾5 And press menu key to change low beam
pattern.
F. Repeat from D to E until getting that Coordinate of color is X=273¡¾5, Y=280¡¾5.
G. To exit from Service Mode, press S8 on the remocon (when Service Remocon) or turn
off the TV. (when User Remocon)
-29-