Lenovo NONE FOUND 3000 V100 Service And Troubleshooting Manual page 37

8. With the notched end of the SO-DIMM toward the contact edge side of
the socket, firmly insert the SO-DIMM into the socket at an angle of
about 20 degrees 1 , then press it firmly 2 .
9. Push the SO-DIMM down until it snaps into place.
10. Make sure that the memory module is firmly fixed in the slot and does
not move easily.
11. Reinstall the cover of the memory slot by aligning the front side of the
cover first 1 , and closing the cover 2 . Then tighten the two screws
3 .
Attention: When you have replaced the SO-DIMM, do not use your
computer until you have closed the memory slot cover. Never use the
computer with the cover open.
12. Reinstall the battery.
13. Turn the computer over again, and reconnect the ac adapter and cables to
the computer.
2
1
1
2
Chapter 5. Upgrading and replacing devices
Replacing memory
29