Table of Contents
Advertisement
Information menu
Information
The
menu contains information about BIOS
version, CPU data, memory status, etc.
Main menu
Main
The
menu contains the configuration settings of the
system and shows some system information such as SATA mode.
System Time:
•
allows you to set the time of the system. Use
or
-
to change the value.
System Date:
•
allows you to set the date of the system. Use
-
or
to change the value.
Power Save
•
: allows you to decide the functions and devices
that would be enabled and disabled when
is activated. For details, refer to
Lite" on page
5.
Quick Charge
•
: allows you to complete the battery charge
within a short time.
Video Memory
•
: determines the memory size that can be used
by the Internal Graphic Device.
Network Boot
•
: determines whether to allow booting from
LAN.
46
Using BIOS setup
+
Power Save
mode
"Saving power of your Joybook
SATA Mode
•
: sets the hard disk controller to either IDE or
AHCI mode.
• If you intend to disable the hard drive or SSD, note that all
programs installed and data stored on the disabled drive will
not be available. You may not boot into Windows operating
system accordingly.
• Quick charge may cause damage to your battery and affect
battery life. Yet the length of charging time and the battery
+
life may vary as the battery declines in capacity over time.
Security menu
Security
The
menu contains the security settings, which
safeguard your system against unauthorized use.
Do NOT set the BIOS security password without having
memorized it or written it down and stored it with your Joybook
Lite warranty documentation. Should you happen to forget or
mislay the password once set, you will be greatly
inconvenienced in gaining subsequent access to your
Joybook Lite.
•
Set Supervisor Password:
system supervisor's access to the whole BIOS setup utility. It
User Password
must be set before
the password, first make sure Num Lock is off, and then type
your password in the entry field and press <Enter>. Confirm
your password by typing it again and pressing <Enter>.
Set User Password:
•
access to the BIOS setup utility. When typing the password,
first make sure Num Lock is off, and then type your password
This set of password controls the
can be set. When typing
This set of password controls the user's
Advertisement
Table of Contents
