BenQ Joybook Lite U122 Eco User Manual page 55

9. Gently push the free edge downwards until the module locks
into place.
If the memory module is not installed properly, your Joybook
Lite may not boot properly.
10. Replace the memory cover.
11. Use a screwdriver to secure the cover with the screw.
12. Place the battery on its original position (1), and then slide
"Battery retainer A" to the right (2). Connect the power
adapter. When you start the Joybook Lite, it will
automatically test and configure the new memory.
Battery retainer A
It is recommended that you go into BIOS to load setup
defaults after installing additional memory. For details, refer to
"Using BIOS setup" on page 44.
Replacing the memory 51