Specifications; General; Transmitter; Receiver - Alinco DJ-191 Instruction Manual

5. SPECIFICATIONS
III
The specifications outlined for this product are for specified TX range only. No guaran-
tee or warranty, either specific or implied, will apply to any function or specification
outside the specified TX range, even for reception performance. Individual radios may
experience different performance and/or specification levels.
Any modification for the purpose of operation outside of the specified TX range will
result in voiding any warranties associated with this transceiver and may be a violation
of FCC regulations.
All specifications and features are subject to change without notice or obligation.
5
High: Approx. 5W (at 13.8V DC) / Low: Approic. 0.8W
10mW in High or Low for DJ-491C
F3E (FM)
Variable reactance FM
±5kHz
- 70dB or under below carrier level
67.0 to 254.1 Hz (50 selections)
Electret Condenser type
Simplex/Semi Duplex: Offset 5kHz or 12.5kHz steps
Built-in and included
as
standard
Audio Output:
Speaker Impedance:
Selectivity:
5-3 Receiver
Receiving System: Superheterodyne Dual Conversion
Sensitivity (12dB SINAD): DJ-191 Less than -ladB/L
DJ-491 Less than -12dB/L
Intermediate Frequency: DJ-191 1st IF 21.7MHz /2nd IF 450kHz
DJ-491 1st IF 45.1 MHz / 2nd IF 455kHz
More than ± 6kHz at - adB,
Less than ± 12kHz at - 60dB
More than 200mW (at 10% THD)
80
Emission Mode:
Modulation System:
Max. Freq. Deviation:
Spurious Emission:
Tone Frequency:
Microphone:
Operating Mode:
CTCSS Encoder:
Output Power:
5-2 Transmitter
AX TX
136.000"': 173.995MHz 144.ooo-147.995MHz
144.000 -145.995MHz 144.000 -145.995MHz
136.000 -173.995MHz 136.000 -155.oooMHz
136.ooo-173.995MHz 150.ooo-173.995MHz
433.0625-434.7875MHz 433.0625-434.7825MHz
400.000 - 420.oooMHz 400.000 - 42O.oooMHz
450.000 - 470.oooMHz 450.000 - 470.oooMHz
430.000 - 450.oooMHz 430.000 - 450.oooMHz
5, 10, 12.5, 15,20,25, 30kHz steps
40 Channels
+
1 Call Channel Memory
50 Ohms unbalanced
±5ppm
2K Ohms nominal.
F3E (FM)
4.8 -13.8V DC (4.8V DC standard)
Transmitting: Approx. 1.5 Amp. in High Power
Setting (0.1 Amp for DJ-491C)
Receiving: Squelched Approx. 50mA
-10 to +60 degrees (Celcius),
14 to 140 degrees (Fahrenheit)
Negative
57(W)
x
151(H)
x
28(D) mm
without projections, with EBP-37N
Approx. 300g (with EBP-37N)
16 Buttons Keypad
Encoder installed (50 tones)
ET5-300220 (for DJ-491 Conly)
Ground:
Dimensions:
Weight:
DTMF:
Subaudible Tones (CTCSS):
European Standard:
Frequency Coverage
DJ-191T
(U.S. Am8letI'Version)
DJ-191 E
(European AmaIeur Version)
DJ-191TA1
(CommeR:iaI Version)
DJ-191T A2
(CommeR:iaI Version)
DJ-491 C
(EufqJean LPD Version)
DJ-491TA1
(CommeR:iaI Version)
DJ-491T
A2
(CommeR:iaI Version)
DJ-491 TA3
(CommeR:iaI Version)
Channel Spacing:
Memory Channels:
Antenna Impedance:
Frequency Stability:
Microphone Input Impedance:
Signal Type:
Power Supply Requirements:
Current Consumption
at 13.8V DC:
Operating Temperature:
5-1 General
4