Resetting - Alinco DJ-191 Instruction Manual

III
24
4. Press and hold the MONI key, then press the PTT switch
three times
on both
radios.
The" [
Lon
E..
icon will appear on the LCD of both radios.
5. Press the MONI key of the radio receiving the information to be copied (SLAVE
RADIO).
The" ,.
ERd
~
..
icon will appear on the LCD.
6. Press the PTT switch of the radio (MASTER RADIO) whose memory will be trans-
fered to the slave radio.
The"
PU5h ..
icon will appear on the LCD. Press the PTT switch again on the
master radio to start transfer of information data.
7. During the cloning, the"
5E nd ..
icon will appear on the LCDofthe master radio,
and the"
GEl:"
icon will appear on the LCD of slave radio. After the cloning, the
.. End ..
icon will appear for two seconds on the LCD of slave radio.
8. Turn the power off on both radios.
9. Disconnect the interface cable.
Clone interface cable should be
built as follows:
• 3.5<1> Stereo plug •
8-5 Resetting
(Not applicable for DJ-491 C)
While pressing the
iii
key, turn on power.
DJ·191TfTA1fTA2 DJ-191E
DJ-491TA 1
fT
A2ITA3
VFO Frequency
145.000MHz 145.000MHz 445.000MHz
Channel Step 5kHz
12.5kHz 5kHz
Shift
None None None
Offset Frequency
0.6kHz 0.6kHz
0.6kHz
C811
Frequency 145.000MHz
145.000MHz 445.000MHz
DSO Setting
None None
None
DSaCode
None None
None
Auto Dialer Code
None None None
Tone Setting
None None
None
Tone Frequency 88.5Hz 88.5Hz
88.5Hz
Transmitter Output Low
Low Low
Key Lock Off Off
Off
Time Out Timer Off
Off Off
Low PowerfTone Burst
LowPTT Tone Burst
LowPTT
Battery Save function
On On On
DTMF pause before first digit 0.4 0.4
0.4
25