Introduction; Accessories; Standard Accessories - Alinco DJ-191 Instruction Manual

1. INTRODUCTION III
2. INNOVATIVE AND NEW FEATURES .111
We at Alinco would like to thank you for purchasing the ALiNCO transceiver. Radios
and other products made by ALI NCO rank as some of the finest in the world. Your
transceiver has been manufactured and tested very carefully at the factory and will give
you satisfactory operation for many years.
We are confident that you will be very satisfied with your choice of this fine ALI NCO
radio.
The transceiver features some of the most advanced features and reliable engineering
available anywhere. Our design policy at ALiNCO is focused on developing innovative
usable features, including the following:
• Easy to readout LCD.
• Comes equipped with a 50 CTCSS Tone encoder, and with the optional EJ-28U Tone
Squelch Decoder unit, the CTCSS Tones can be decoded for selective receiving.
• Tone Burst (1750Hz) feature comes built into the transceiver.
• T.O.T. (Time Out Timer) can be set to a Duty Cycle most accommodating to the
user's requirements.
• Nine Autodial Memories easily accessed from the DTMF keypad with redial
function.
• Cable Cloning function. (not for DJ-491C)
• Direct frequency entry from the DTMF keypad
• Independent Low power output PIT key (DJ-191T/491TA1- TA3)
• Independent TX LED and RX LED
III
3. ACCESSORIES
3·1 Standard Accessories
Information in this document are subject to change wihout notice or obligation.
All brand names and trademarks are the property of their respective owners.
Alinco cannot be liable for pictorial or typographical inaccuracies. Some options
and/or accessories are unavailable in certain areas. ©Copyright 1996-1997 All
rights reserved. No part of this document may be reproduced, copied, translated
or transcribed in any form or by any means without the prior written permission
of Alinco, Inc., Osaka, Japan. English Edition Printed in Japan
NOTICE
This equipment has been tested and found to comply with the limits pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection aginst harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be'determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures.
• Reorient to relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that which the receiver is onnected.
• Consult the dealer or an experienced radio/TV technician for help.
When you unpack the ALiNCO transceiver, you will find these standard accessories:
• Ni-Cd battery (optional for DJ-491C)·
• EDC-63 (120V AC) Wall charger (T Version)·
• EDC-64 (220V AC) Wall charger (E Version)·
• Flexible rubber duckie antenna (not applicable for DJ-491 C)·
• Belt clip with two screws
• Hand strap
• Instruction Manual
·Accessories may differ depending on the version you bought.