Pride Laser Owner's Manual page 30

I X . D I S A S S E M B L Y A N D A S S E M B L Y
ASSEMBLY
NOTE: Raise the tiller before starting to assemble the Laser.
1. Place the manual freewheel lever in the drive (down) position.
2. Position the front and rear sections next to each other.
3. Tilt the rear end to a horizontal position and insert the longer tube of the front end into the rear section first;
make sure that the locking cam levers are in the unlocked (vertical) position and the ball detent pins are
removed.
4. Slide the two sections of the unit together until the front half reaches its insertion limit.
5. Secure the front and rear sections with the ball detent pins.
6. Push the frame lock levers back to their locked (downward) position.
7. Plug the silver front-to-rear harness into the mating plug found on the electronics module.
8. Put the batteries in place and plug the black and white 2-pin battery harnesses into the electronics module.
9. Reconnect the battery tie-down straps (if so equipped).
10. Gently place the rear shroud over the seat pedestal.
11. Slide the shroud down in place.
12. Carefully lift the seat and slide the small seat post (on the seat bottom) into the seat pedestal.
13. Rotate the seat until it locks into place.
30 Laser