Ice Tray - Hitachi R-S47AMJ How To Use Manual

Ice
Compartment

Ice tray

Maintain it once a year
Push the 製冰 button to stop supplying
1
water to the ice tray and turn on the 停止
indicator lamp. (Stop ice making)
If the indicator lamp fl ashes,
perform the following operation
after the " " lamp is turned on
in 20 seconds.
Open the Ice Compartment Door.
2
Pull down the lever and
frame.
Raise the cover (
direction of the arrow.
Remove the ice tray from the frame.
Cover
Frame
Notice
If you cannot push the frame of the ice tray into the end, the ice tray drive motor may have operated.
Remove the ice tray once and push the frame in, and wait 1 minute after closing the Ice Compartment Door.
Preparation for the ice tray drive motor fi nishes, and you can set the ice tray.
Light ON
Press this button to turn on
the indicator lamp.
draw the
part) in the
Lever
part
Notice
Wash the water supply container thoroughly and replace it
after drying it if you stop ice making and you are not to use the
Automatic ice maker for a while.
In particular, dry the water fi lter thoroughly.
Warning
Do not put your hand in the mechanical part
of the Automatic ice maker.
● You may be injured when the Ice tray turns.
Empty the ice tray and wash it lightly
3
in the stream.
Set the ice tray and
4
cover.
Make the frame horizontal and
push it into the end, and
Pull up the lever.
Click
Is the lever in
horizontal state?
Push the 製冰 button to turn on either
Large or Normal indicator lamp.
(Automatic Ice Making starts)
Light ON
Do not use
any cleaning tool that
can scratch it easily such
as scrubbing brush and
plate powder.
close the
Lever
Horizontal
Push this button to turn
on the indicator lamp
49