Lennox Hearth Products LSO-43 Installation Instructions

INSTALLATION INSTRUCTIONS FOR OUTDOOR BI-FOLD GLASS DOORS
These bi-fold glass door assemblies have been designed for use with
and may be easily fitted to your Lennox Outdoor Fireplace, Models:
LSO-43, LSO-43-H, MP-36OD & MP-42OD.
Do not alter or modify these door assemblies or a fireplace malfunction
or a fire hazard may result.
These doors have been tested and listed by Omni-Test Laboratories
Inc.
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE.
GENERAL INFORMATION
The door assembly consists of a right and left glass panel assembly
with the door handles factory mounted. There are no additional parts
that are required to install these doors. Fireplaces listed on the front
page of this document, have been designed to accept these doors with
minimum effort.
TOOLS REQUIRED
Medium Phillips Screwdriver • ³⁄₈" Open-end wrench
INSTALLATION PROCEDURE
Step 1. Starting with the lower end of either the right or left hand door
hold the door at a slight angle to the door frame outer edge with the
top tilted toward the center.
43LBFOD-BS, 42ABFOD-BS & 36ABFOD-BS
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE
750,141M
06/2006
Swing the lower corner of the door over the hole in the lower frame
and engage the lower pivot pin into the hole on the lower frame of the
firebox opening ( Figures 1 and 2 ).
Pivot Pin
Lock
Figure 1
Step 2. Tilt the top of the door into place and carefully ensure that the
upper pivot pin and roller pin is in the upper door guide track.
Step 3. Continue to tilt the top of the door into place until the upper
pivot pin engages the spring clip and the pivot pin locks into place
within the hole of the spring clip ( see Figure 3 ).
Lower
Pivot Pin
Figure 2
Step 4. Repeat this procedure for the opposite door assembly.
FIREPLACE KITS
AND ACCESSORIES
BI-FOLD GLASS DOORS
Roller Pin
Pivot
Point
Lower
Frame