Connecting Rj45 Ethernet Cable - Vivotek FE8191 User Manual

VIVOTEK

Connecting RJ45 Ethernet Cable

RJ45 Cable Dimension
Recommended cable gauge: (0.51 cm)
Assembly Steps
1. Drill a hole on the rubber seal plug and
insert an Ethernet cable through the
opening.
2. Strip part of the sheath from the Ethernet
cable.
3
o: white/orange stripe
o
O: orange solid
O
g
g: white/green stripe
B
B: blue solid
b
b: white/blue stripe G
br
G: green solid
BR
br: white/brown stripe
BR: brown solid
4
Connecting DC Power Cable
1. Add the supplied rubber washer to the cable as
shown in the picture.
2. Feed the cable from the bottom of the camera
and tighten the plastic base for waterproofing.
NOTE:
Connect the supplied power & IO cables if your
switch does not support PoE.
14 - User's Manual
1
3. You will need an RJ45 crimping tool to
attach the Ethernet wires to a connec-
tor. When done, connect the cable to
1
the camera's Ethernet RJ45 socket.
2
3
4
5
6
7
8
4. Feed the Ethernet cable from the bottom of the
camera and through the hole. Attach the rubber seal
plug for water proofing.
1
2
Rubber Seal Plug
2