Vision Fitness R2000 Assembly Instruction Manual page 4

R2000
Step 1 • Seat Support and Rear Foot
Attach the Seat Rail Support Post (96) to the top of the Rear Foot Assembly
1:
(106) with four Bottom Support Post Bolts (186), four Washers (184) and
Bolt Plate (91). Tighten with a 5mm allen wrench.
Step 2 • Seat Rail
1: Place the Seat Rail (121) on the Seat Rail Support (96). Thread the four
Attachment Bolts (182) with Washers (184) through the top of the Seat
Rail Support (96) into the Seat Rail (121).
2: Slide the Seat Frame (115) onto the Seat Rail (121) from the front of the
Seat Rail. After the Seat Frame (115) is on the Seat Rail (121) insert the
Seat Knob (520) into a hole to prevent the Seat Frame (115) from sliding
forward.
3: Slip the Rubber Seat Rail Cap (133) onto the front end of the Seat Rail
(121), slide the Rubber Seat Rail Cap (133) back to expose the three front
attachment bolt holes.
4: Place the Seat Rail Assembly (121) into the main frame bracket. Thread the
three Attachment Bolts (182) with Washers(184) through the Seat Rail
(121) in the main frame bracket. Tighten all Attachment Bolts (182)
securely to the main frame bracket. Slide down the Rubber Seat Rail Cap
(133) until it is flush with the side covers.
5: Place the seat rail end cap over the rear end rail and snap to the top of the
seat rail end post.
Note: ALWAYS HOLD THE SEAT KNOB OUT WHEN ADJUSTING THE SEAT
HEIGHT. TURN THE INNER KNOB CLOCKWISE TO LOCK IN PLACE.
Assembly
523
121
184
182
96
END CAP
SIDE VIEW
FRONT VIEW