Supero SUPERSERVER 1027R-WRF User Manual page 61

Watch Dog Enable/Disable
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when a
software application hangs. Close Pins
1-2 to reset the system if an applica-
tion hangs. Close Pins 2-3 to generate
a non-maskable interrupt signal for the
application that hangs. See the table
on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.
VGA Enable/Disable
Jumper JPG1 allows the user to enable
the onboard VGA connector. The default
setting is 1-2 to enable the connection.
See the table on the right for jumper
settings.
BMC Enable
Jumper JPB1 allows you to enable
the embedded the Renesas BMC
(Baseboard Management) Controller to
provide IPMI 2.0/KVM support on the
motherboard. See the table on the right
for jumper settings.
I2C Bus to PCI-Exp. Slots
Jumpers JI 2 C1 and JI
to connect the System Management
2
Bus (I C) to PCI-Express slots. The
default setting is Open to disable the
connection. See the table on the right
for jumper settings.
Chapter 5: Advanced Serverboard Setup
2 C2 allow you
5-27
Watch Dog Enable/Disable
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
BMC Enable/Disable
Jumper Settings (JPB1)
Jumper Setting Defi nition
Pins 1-2 BMC Enable
Pins 2-3 Normal (Default)
I2C to PCI-Exp
Jumper Settings
Jumper Setting Defi nition
Closed Enabled
Open Disabled (Default)