Supero SUPERSERVER 1027R-WRF User Manual page 52

SUPERSERVER
PW_ON Connector
The Power Button connection is located
on pins 1 and 2 of JF1. Momentarily
contacting both pins will power on/off
the system. This button can also be
confi gured to function as a suspend
button (with a setting in the BIOS - See
Chapter 5). To turn off the power when
the system is in suspend mode, press
the button for 4 seconds or longer.
Refer to the table on the right for pin
defi nitions.
Reset Connector
The reset connector is located on pins 3
and 4 of JF1 and attaches to the reset
switch on the computer chassis. See
the table on the right for pin defi nitions.
Power Fail LED
The Power Fail LED connection is
located on pins 5 and 6 of JF1. Refer to
the table on the right for pin defi nitions.
Overheat/Fan Fail LED (OH)
Connect an LED cable to pins 7 and
8 of Front Control Panel to use the
Overheat/Fan Fail/Power Fail and UID
LED connections. The Red LED on
pin 7 provides warnings of overheat,
fan failure or power failure. The Blue
LED on pin 8 works as the front panel
UID LED indicator. The Red LED takes
precedence over the Blue LED by
default. Refer to the table on the right
for pin defi nitions.
1027R-WRF USER'S MANUAL
Power Button
Pin Defi nitions
Pin# Defi nition
1
2
Reset Button
Pin Defi nitions
Pin# Defi nition
3
4
PWR Fail LED
Pin Defi nitions (JF1)
Pin# Defi nition
5
6
OH/Fan Fail/ PWR Fail/Blue_
UID LED Pin Defi nitions (JF1)
Pin# Defi nition
7 Red_LED-Cathode/OH/Fan
Fail/Power Fail5.5V.SB
8 Blue_UID LED
OH/Fan Fail/PWR Fail
LED Status (Red LED)
State
Off
On
Flashing
5-18
(JF1)
PW_ON
Ground
(JF1)
Reset
Ground
3.3V
PWR Supply Fail
Indication
Normal
Overheat
Fan Fail