Starting To Sew; Threading The Needle - Brother M945 Super ACE III Quick Start Manual

Step 6
• Pass the thread behind the needle guide, leaving about
15cm (6in) of thread trailing (
• Pull the thread out to the left, underneath the
threading guide ( figure 6b
• Push the needle threader lever downwards, at the
same time gently pulling the thread forwards so that it
hooks around threading guide (
• Continue pushing the lever all the way down, so that
the threader rotates to engage with the needle
( figure 6d ).
The threader hook will pass right through the eye of
the needle from the back.
• Pull the thread to the right across the threader, where it
should slip under the hook (
• Holding the thread loosely, release the needle threader
lever, so that the hook comes back out of the eye and
the threader springs back upwards.
The hook should pull a loop of thread through the
needle ( figure 6f ). If it does not, then try again.
Pull the loop to draw the thread all the way out
through the back of the needle.
• Raise the presser foot, and pass the thread between the
toes of the foot, and out towards the back of the
machine.

Starting to sew.

• Set the power switch to on (I).
Make sure the presser foot is up by pushing the presser foot lever upwards,
and the needle is at its highest position by pressing the needle position button.
Place the fabric under the foot with the needle about 1 cm (3/8 in) from the rear
edge of the fabric, and lower the presser foot onto the fabric.
• Set the sewing speed control to midway (until you are used to the machine).
To start sewing, press the start/stop button or use the foot controller.
To stop, press the start/stop button again or release the foot controller.
To reverse sew, press and hold the reverse stitch button.
• When you have finished sewing, raise the presser foot and the needle.
Gently pull the fabric out, and cut the thread using the thread cutter (
To learn how to use the more advanced features of the Super ACE III sewing machine, you should read the Instruction Manual.
For further assistance, phone: 0870 830 4020, email: support@brother-support.co.uk

Threading the needle.

figure 6a ).
).
figure 6c ).
figure 6e ).
or visit our website: www.brother-support.co.uk
Thank you for choosing a Brother product.
figure 6a
needle
guide
figure 6c
needle
threader
lever
figure 6e
).
figure 7
figure 6b
figure 6d
figure 6f
hook
figure 7
thread cutter
threading
guide
threader