Upper Threading - Brother M945 Super ACE III Quick Start Manual

Step 5
Important:
• Raise the presser foot by pushing the presser foot
lever upwards (
figure 5a
• Raise the needle by pressing the needle position
button ( ).
figure 5b
Place a spool of thread on the spool pin as described
at the beginning of step 3, opposite.
• Unwind about 500mm (20in) of thread and, holding
the thread with a finger as shown, pass it under the
thread guide and forwards down the slot (
• Pass the thread down to the right of the take-up lever
guide, then under the guide and back up the left side
( figure 5d ).
• Pull the thread up the left side of the take-up lever
guide, and all the way to the back of the slot
( ).
figure 5e
• Pull the thread over to the left, then back downwards
again ( ).
figure 5f
This should hook the thread around the take-up lever,
which is just visible inside the slot. If it does not, then
try again.
Important:
• Lower the presser foot by pushing the presser foot
lever downwards (
figure 5g

Upper threading.

).
figure 5c
).
figure 5a
figure 5c
).
figure 5d
take-up
lever
figure 5e
figure 5g
figure 5b
figure 5f