Removing The Power Trim And Tilt Unit - Yamaha F80B Service Manual

Removing the power trim and tilt unit

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
1
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the power trim and tilt unit
should lose fluid pressure.
NOTE:
• If the power trim and tilt does not operate,
loosen the manual valve and tilt the out-
board motor up manually.
• If the manual valve is loosened, be sure to
tighten it to the specified torque after tilting
the outboard motor up.
Manual valve:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
2. Remove the holders 2 and plastic ties,
and then pull out the PTT motor leads 3.
3. Remove the bolt 4 and disconnect the
ground lead 5.
6D93G11
4. Remove the circlips 6, then the lower
mounting shaft 7.
5. Remove the circlip 8, then the upper
mounting shaft 9.
NOTE:
Hold the power trim and tilt unit with one
hand, and pull the upper mount shaft out at a
downward angle with the other.
6. Remove the power trim and tilt unit 0.
S6D83150
3
S60C7745
Power trim and tilt unit
8
9
2
6 7
6
1
2
3
0
4
4
5
S6D87280
5
6
7
8
9
7-24