Panel Installation/Removal - Pacific energy BROADWAY Installation And Operating Instructions Manual

INSTALLER
INFORMATION
Installation
NOTE: Air Deflector from burner kit needs to be
installed before panels. See Burner Kit Installation.
1. Insert back panel so that it is sitting on
ledge at the back of the firebox as shown in
Figure 31.
2. Insert first side panel by inserting the front
edge of the panel into the lip at the front of
the firebox. Then slide the back of the panel
until it reaches the firebox side wall.
Figure 32.
3. Repeat steps 2 for the second side panel.
4. To hold panels in place, install the baffle,
from the burner kit, by resting the back
flange on top of the back panel and use two
screws to secure the front of the baffle to
the top of the firebox, seen in Figure 33.
Removal
1. Remove the baffle by removing screws
securing the front edge of the baffle seen in
Figure 33. After removing the two screws
you can slide the baffle out of the fireplace.
2. Remove first side panel by pulling the back
edge of panel out away from the firebox
wall until there is enough room to remove
the front edge of the panel from the lip at
front of firebox. When you have enough
firebox lip and remove from fireplace.
3. Repeat step 2 to remove second side
panel.
4. Remove back panel by tilting the top
forward and then pull out of fireplace.
Panel Installation / Removal
26
Figure 30: Panel Set
Figure 31: Back Panel
Figure 32: Side Panel
Figure 33: Baffel Mounts