Clone - Vertex Standard VX-2500U Service Manual

Clone

The VX-2500 includes a convenient "Clone" feature,
which allows the programming data from one trans-
ceiver to be transferred to another VX-2500. Here is
the procedure for Cloning one radio's data to anoth-
er.
Note: Enable the "Clone" function in the [Common
2-Radio advanced setting] menu of the CE52.
1. Turn both transceivers off.
2. Connect the optional CT-4 cloning cable between
the Microphone jacks of the two transceivers.
3. Press and hold the A Button and
Button while turning the transceiver on.
4. "CLONE" will appear on the displays both trans-
ceivers when clone mode is successfully activat-
ed in this step.
5. On the Destination transceiver, press the
Down ] Button. "LOADING" will appear on the
LCD.
24
[ Ch. Down ]
[ Ch.
Optional cable:CT-4
[ Ch. Up ] Button on the source trans-
6. Press the
ceiver, "SENDING" will appear on the source
transceiver, and the data will be transferred.
7. If there is a problem during the cloning process,
sound an error beep from source the transceiver.
Check your cable connections and battery volt-
age, and try again.
8. After completing the data transfer (clone),
"COMPLETE" will appear on the LCD. Tune
transceiver off and disconnect the CT-4 cable.
You can then turn the transceiver back on and
begin normal operation.