Table of Contents
Advertisement
If the speaker fuses for the Power 100HD
will blow if the speaker shorts. Replace only with recommended fuse.
SPECIFICATIONS
POWER RATINGS:
4 Ohms:
4 Ohms: 30 Watts per channel continuous power, 4 channels driven into 4 Ohms at 1000 Hertz,
2 Ohms: 25 Watts per channel continuous power, 4 channels driven into 2 Ohms, from 20 to
POWER
4 Ohms: 60 Watts per channel continuous power into 4 Ohms, 2 channels driven, from 20 to
Frequency response: 20 to 100,000 Hertz +.5 -3 dB.
Damping Factor:
Signal to noise ratio:
Slew factor:
IM distortion (IHF):
Input Gain:
Protection
The Power 100HD
fuses
provide
Dimensions:
15 Watts per channel continuous power, 4 channels driven into 4 Ohms, from 20 to
20,000 Hertz, with less than 0.05% THD + N (Total Harmonic Distortion plus Noise).
with less than 0.1% THD + N.
20,000 Hertz, with less than 0.10% THD + N (Total Harmonic Distortion plus Noise).
RATINGS:
2 CHANNEL (Bridged)
20,000 Hertz, with less than 0.1% THD + N.
At circuit board:
over 50 (referred to 4 Ohms)
Over 80 dB, unweighted.
over 5
Less than 0.05%
Variable from 40 dBV to 14 dBV
Factory pre-set at 28 dBV
500
millivolt-rated
:
is protected externally by a
internal
protection.
10 inches Long by 7 inches Wide by 1.5 inches High
are excessively large or are eliminated, the internal fuses
(correct for
source
units).
15 Ampere in-line fuse
15 Ampere in-line
6
fuse, and Eight 4-Ampere blade
Advertisement
Table of Contents
