The amplifier’s signal input female RCA jacks should be connected to the source unit’s signal outputs. (See Figure Four For Connections) If the source unit has “RCA" jack outputs, connect the Power 100HD to the source with an “RCA" adapter cable. In most cases, system noise rejection will be improved by using high-quality braided-shield or double-shielded interconnecting cables.
If the volume control of the source is “touchy” and/or noisy and if just a little volume from the source drives the amplifier into distortion, reduce the Power 100HD input gain controls so that the distortion does not start until the source volume is at about 3/4 of its rotation.
POWER CONNECTION (WHITE 12-GAUGE WIRE) (WHITE 12-GAUGE WIRE) The White wire must be connected directly to the positive terminal of the battery to provide a power source with a low voltage drop and low noise. If the power is connected to any other point (the fuse block, for instance) the amplifier’s power output will be reduced and oscillations and noise may distort the sound.
18-Gauge wire is the smallest we suggest; for runs over 6 feet, 16-Gauge should be used. Many users find that sound quality is improved by the use of specially-made heavyduty speaker wiring. The Power 100HD output harness uses short runs of 1 6-Gauge wire and should not reduce any benefits gained from specialized speaker wiring.
If the speaker fuses for the Power 100HD are excessively large or are eliminated, the internal fuses will blow if the speaker shorts. Replace only with recommended fuse. SPECIFICATIONS POWER RATINGS: 4 Ohms: 15 Watts per channel continuous power, 4 channels driven into 4 Ohms, from 20 to 20,000 Hertz, with less than 0.05% THD + N (Total Harmonic Distortion plus Noise).
SPEAKERS, RETURN THE PRODUCT TO YOUR NEAREST ROCKFORD FO SGATE DEALER OR CALL 602-967-3565 FOR THE DEALER NEAREST YOU. All products must be returned, freight prepaid, to an authorized Rockford Fosgate repair center where it will be repaired or replaced, at our option, and returned to you prepaid.