Utility; Utility-Diagnosis - Panasonic KX-TDE100 Programming Manual

2.6.1 Utility—Diagnosis

2.6 Utility

2.6.1 Utility—Diagnosis
Performs diagnostic tests on cards installed in the PBX, to identify the source of problems.
If any of the tests listed here returns the result "NG" ("No Good"), contact your dealer. Test results can be
saved as a TXT-format (text) file.
When testing is complete, any cards that were set to OUS status must be returned to INS status if they are to
be used again.
Card Test
Tests the relevant functions of a card to ensure that it is operating correctly. The tests carried out vary according
to the type of card being tested.
The tests that are performed on each card are as follows:
Test Type
Local loop back diagnosis
Card CT Bus diagnosis
(KX-TDE100/KX-TDE200 only)
DTMF Receive test port
PT loop back diagnosis
DSP DTMF generator/receiver
diagnosis
DSP DTMF receiver diagnosis
Framer IC alarm signal detection
diagnosis
Framer IC error detection diagnosis
CS-INF loop back diagnosis
Super frame synchronization
diagnosis
Caller ID card loop back diagnosis
Extension mode setting test
IP-GW H.323 call simulate diagnosis
LAN loop back diagnosis
To perform a card test
1.
From the Utility menu, select Diagnosis.
2.
Click on the Status cell of the card to be tested, and set it to "OUS".
64 PC Programming Manual
DHLC, DLC, SLC8, SLC16, MSLC16, ESLC16, EMSLC16,
CSLC16, ECSLC24, CSIF, LCOT, ELCOT, T1, E1, BRI, PRI, OPB,
E&M, DID, IP-EXT
DHLC, DLC, SLC8, SLC16, MSLC16, CSLC16, CSIF, LCOT, T1,
E1, BRI, PRI, OPB, E&M, DID, IP-EXT
DHLC, SLC8, SLC16, MSLC16, ESLC16, EMSLC16, CSLC16,
ECSLC24, E&M, DID
DHLC, DLC
T1, E1
T1, E1
T1, E1, PRI
T1, E1, PRI
CSIF
CSIF
LCOT, ELCOT
BRI
IP-GW4, IP-GW16
IP-GW4
Available Cards