Sony DCR-SR58E Service Manual page 15

Assembly-1: How to distinguish the side of Optical Filter
Block facing to Lens Device
The one side of the Optical Filter Block has treated
with IR cut coating.
Mount the Optical Filter Block facing the IR cut
coated side to the lens device.
Distinguish the IR cut coated side from the other by
applying the fluorescent light to
the Optical Filter Block in the dark place
(cut off the outside light).
Optical Filter
Block
Hold it with tweezers or the like.
[IR Cut Coated Side] [The Other Side]
Lens Device side
• The other surface
The red coating is
not reflected. • Side view
The red belt
is seen.
• IR cut coating surface
The red coating is reflected.
Lens Device side
Assembly-2: Precaution Mounting method of D901
(LED video light)
11.5mm
Diode (NSPL500DS)
5.7mm
Bend Cut
Precaution the polarity.
DA-049 Board
DCR-SR58E/SR68/SR68E/SR78E/SR88/SR88E_L2
Assembly-3: The Method of attachment of FP-1239
Flexible Board
1 Fold dotted line parts of the FP-1239 flexible board
as shown in figure.
Adhesive
tape
Valley fold
FP-1239
Flexible
Board
Valley fold
Mountain fold
Mountain fold
Adhesive part
Adhesive part
Adhesive part
Unite
corners.
3. ASSEMBLY
2 Put FP-1239 Flexible Board on the Hinge Assy
as shown in figure.
Adhesive Part
3 Install the flexible clamp in the hinge assy
as shown in figure.
Flexible clamp
4 Install the hinge cover (M) and magnet.
Hinge Cover (M)
Put the marking side
together on the position
of figure.
Magnet
Marking
3-1E
5 Install the hinge cover (C).
Hinge Assy
Hinge Cover (C)
Claws
6 Roll the FP-1239 flexible board 2 times in
the hinge assy as shown in figure.
2 times